LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Mechanical - 2.2L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner And Special Tool
    GM854300Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine splash shield. Refer to Engine Splash Shield Replacement - Right Side .
  2. Install the J 44811  to the drive belt tensioner. See Special Tools .
  3. Using the J 44811  , rotate the tensioner counterclockwise in order to release the tensioner from the drive belt. See Special Tools .
    4. Fig 2: Drive Belt
    GM1571093Courtesy of GENERAL MOTORS CORP.
  4. Remove the drive belt.
  5. Slowly rotate the J 44811  and the tensioner clockwise in order to allow the tensioner to rest. See Special Tools .
  6. Remove the J 44811  from the drive belt tensioner. See Special Tools .
scientia non olet · About LEMON Manuals