Exhaust Leakage

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Problem	Action
WARNING: While engine is operating, the exhaust system will become extremely hot. To prevent burns avoid contacting a hot exhaust system. DEFINITION: An exhaust leak may show stains at the area of the leak. The leak may be felt by holding a hand close to the suspected areas or using a smoke pencil. The leak may make a popping or hissing noise.Refer to Symptoms - Engine Exhaust prior to beginning this table.
Misaligned or improperly installed exhaust system components	Align and tighten the components to the specifications. Refer to Fastener Tightening Specifications .
Exhaust leaks at the following connections: Exhaust manifold to pipe Flanges Pipe clamps	Tighten the components to the specifications. Refer to Fastener Tightening Specifications .
Seals or gaskets leaking. Exhaust manifold to cylinder head Exhaust pipes to exhaust manifold Catalytic converter connection EGR connections AIR connections to the exhaust manifold or cylinder head	Replace the leaking seal or gasket. Refer to the affected components procedure for service.
Irregularities at the mating surfaces on the flange connections	Repair as required or replace the affected component. Refer to the affected components procedure for service.
Exhaust manifold cracked or broken	Replace the exhaust manifold. Refer to Exhaust Manifold Replacement (LNF) or Exhaust Manifold Replacement (LAP) .
Exhaust system component connection welds leaking	Replace the leaking component. Refer to the affected component's procedure for service.
Muffler or resonator, if equipped, damaged or leaking at the seams	Replace the affected muffler. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (LNF) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (LAP) .