LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Manual Transmission - Mu3) >> Repair Instructions - On Vehicle >> Axle Seals Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Front Wheel Drive Intermediate Shaft Replacement .
    4. Fig 1: Removing Front Wheel Drive Shaft Oil Seal
    GM863208Courtesy of GENERAL MOTORS CORP.
  4. Use the J 23907  or J 44809  in order to remove the seal. See Special Tools .
  5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.
scientia non olet · About LEMON Manuals