Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Use the J 23907 or J 44809 to install a new seal. See Special Tools . Ensure the seal is seated flush to the outer bore area.
- Install the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Front Wheel Drive Intermediate Shaft Replacement .
- Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.