Clutch Housing Disassemble: Disassemble

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing Out Input Shaft Bearing Race

Courtesy of GENERAL MOTORS CORP.

Press out the input shaft bearing race using the 87 91 204 . See Special Tools . Use the 87 92 236 as a base for pressing operation. See Special Tools .

Fig 2: Tapping Out Axle Seal

Courtesy of GENERAL MOTORS CORP.

Tap out the axle seal and discard.

Fig 3: Tapping Out Differential Bearing Race

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: When driving to the differential bearing race, tap equally on the opposite sides of the race to avoid damaging the race bore and seal surface.

Tap out the differential bearing race using a punch and hammer.