LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement (Disc) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor console. Refer to Front Floor Console Replacement .
  2. Ensure that the park brake lever is in the fully released position.
    3. Fig 1: Locating Parking Brake Cable Adjusting Nut
    GM891460Courtesy of GENERAL MOTORS CORP.
  3. Release the tension from the park brake cables.

    Using ONLY HAND TOOLS, loosen the adjusting nut (1) completely to the end of the front cable threaded rod.

    4. Fig 2: View Of Park Brake Lever Bracket, Rear Cable Fittings, & Rear Cable Ends
    GM1395425Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear seat lower cushion. Refer to Rear Seat Cushion Replacement .
  5. Remove the rear carpet retainers. Refer to Rear Side Door Opening Floor Carpet Retainer Replacement .
  6. Position the carpet forward in order to access the rear park brake cables and body pass-thru grommets.
  7. With the park brake lever in the released position, release the appropriate rear park brake cable end (3) from the cable equalizer.
  8. Release the rear cable fitting (2) from the park brake lever bracket (1) and remove the cable from the lever assembly.
  9. Release the rear park brake cable body pass-thru grommet.
    10. Fig 3: View Of Park Brake Cable Underbody Retainer, C-Shaped Retainer & Pass-Thru Grommet
    GM1385056Courtesy of GENERAL MOTORS CORP.
  10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  11. If the park brake cable is being reused, release the tab on the underbody retainer (2) and remove the park brake cable from the retainer.
  12. If a new park brake cable will be installed, release the underbody retainer (2) from the vehicle underbody.
    13. NOTE: Do NOT pull on the park brake cable to release the C-shaped retainer (1) on the cable from the bracket at the rear axle trailing arm pivot.
  13. Using a suitable tool, carefully pry against the edge of the C-shaped retainer (1) on the park brake cable, to release the retainer from the bracket at the rear axle trailing arm pivot.
  14. Remove the cable from the opening in the vehicle underbody.
    15. Fig 4: View Of Park Brake Cable
    GM1385058Courtesy of GENERAL MOTORS CORP.
  15. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  16. Release the park brake cable end (1) from the caliper park brake lever.
  17. Using a flat-bladed screwdriver, depress the retaining tabs (4) on the park brake cable fitting, and release the cable fitting from the cable bracket.
  18. Remove the park brake cable guide (3) retaining bolt (2), and remove the cable.
scientia non olet · About LEMON Manuals