LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 4T65-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Auxiliary Cooler Inlet and Outlet Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the inlet and outlet auxiliary transmission oil cooler lines to the auxiliary transmission oil cooler. Refer to Transmission Fluid Auxiliary Cooler Replacement .
    2. Fig 1: Support Clip & Inlet And Outlet Auxiliary Transmission Oil Cooler Lines
    GM1666180Courtesy of GENERAL MOTORS CORP.
  2. Install the inlet and outlet auxiliary transmission oil cooler lines (1, 2) to the transmission and radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  3. Install the support clip (3) to the auxiliary transmission oil cooler lines.
  4. Install the auxiliary transmission oil cooler lines to the fan shroud support clip.
  5. Install the lower radiator air baffle. Refer to Radiator Air Lower Baffle and Deflector Replacement .
    6. CAUTION: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  6. Adjust the fluid level.
scientia non olet · About LEMON Manuals