LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Power Steering Fluid Reservoir & Bolts
    GM1856562Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the remote power steering fluid reservoir (2).
  2. Install the remote power steering fluid reservoir bolts (1) and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Power Steering Fluid Reservoir Outlet Hose & Clamp
    GM1856009Courtesy of GENERAL MOTORS COMPANY
  3. Connect the power steering fluid reservoir outlet hose and clamp (1).
    4. Fig 3: Power Steering Reservoir Inlet Hose And Clamp
    GM1856010Courtesy of GENERAL MOTORS COMPANY
  4. Connect the power steering reservoir inlet hose and clamp (1).
  5. Clean all excess fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals