LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Power Steering System) >> Diagnostic Information and Procedures >> Rattle, Clunk, Pop or Shudder Noise from the Power Steering System

Rattle, Clunk, Pop or Shudder Noise from the Power Steering System

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
1 Did you review the Power Steering System General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System 
2 Verify that a rattle, clunk or shudder noise is present.
Is a rattle, clunk or shudder noise present?
Go to Step 3  System OK
3 Inspect the power steering hoses for proper routing and clearance.
Is the routing or clearance of the power steering hoses incorrect?
Go to Step 10  Go to Step 4 
4 Inspect the engine drive belt for excessive wear. Refer to Drive Belt Falls Off and Excessive Wear Diagnosis .
Is the drive belt cracked or excessively worn?
Go to Step 11  Go to Step 5 
5 Inspect the power steering pump pulley for damage.
Is the power steering pump pulley damaged?
Go to Step 12  Go to Step 6 
6 Inspect the power steering pump for the proper installation. Refer to Power Steering Pump Replacement .
Is the power steering pump installation incorrect?
Go to Step 13  Go to Step 7 
7 Inspect the steering gear for the proper installation. Refer to Steering Gear Replacement .
Is the power steering gear installation incorrect?
Go to Step 14  Go to Step 8 
8 Inspect the suspension.
Is the suspension worn?
Go to Step 15  Go to Step 9 
9 Inspect the intermediate shaft.
Is the intermediate shaft worn?
Go to Step 16  Go to Step 3 
10 Adjust or replace the hoses. Refer to the appropriate procedure(s):
Did you complete the repair?
Go to Step 17  -
11 Replace the engine drive belt. Refer to Drive Belt Replacement .
Did you complete the repair?
Go to Step 17  -
12 Replace the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
Did you complete the repair?
Go to Step 17  -
13 Install the power steering pump correctly. Refer to Power Steering Pump Replacement .
Did you complete the repair?
Go to Step 17  -
14 Install the steering gear correctly. Refer to Steering Gear Replacement .
Did you complete the repair?
Go to Step 17  -
15 Replace the worn suspension components.
Did you complete the repair?
Go to Step 17  -
16 Replace the intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
Did you complete the repair?
Go to Step 17  -
17 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3