Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Pass the front door wiring harness electrical connector through the access opening and position the front door wiring harness to the door as previously noted.
- Ensure the front door wiring harness attachments are fully seated.
- Attach the rubber grommet to the door access opening. Ensure the grommet is fully seated.
- Install the front door wiring harness electrical connector to the mounting bracket. Ensure the mounting bracket retaining tab is fully seated.
- Connect the body harness inline electrical connector to the door wire harness electrical connector. Ensure the retaining tab is fully seated.
- Connect the electrical connector to the SIR side impact sensor.
- Connect the door latch assembly electrical connector.
- Connect the regulator motor electrical connector.
- Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the front door speaker. Refer to Radio Front Side Door Speaker Replacement .
- Install the side front door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side (Acadia or Traverse)Front Side Door Trim Panel Replacement - Left Side (Enclave) , or Front Side Door Trim Panel Replacement - Right Side (Enclave)Front Side Door Trim Panel Replacement - Right Side (Acadia or Traverse) .
- Enable the SIR. Refer to SIR Disabling and Enabling .