LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Door Opening Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Pinch-Weld Flange Weatherstrip (Front Door Opening)
    GM686582Courtesy of GENERAL MOTORS COMPANY
  1. Align the weatherstrip (1) to the door opening with the bond joint positioned at the lower center of the door opening.
  2. Install the weatherstrip to the pinch-weld flange. Ensure the weatherstrip is fully seated.
  3. Install the center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement (Traverse)Center Pillar Lower Garnish Molding Replacement (Acadia or Enclave) .
scientia non olet · About LEMON Manuals