LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Transfer Case - GETRAG 790) >> Repair Instructions - On Vehicle >> Input Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement .
  3. Remove the propeller shaft. Refer to Propeller Shaft Replacement .
  4. Remove the right wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement .
  5. Remove the exhaust flexible pipe. Refer to Exhaust Flexible Pipe Replacement .
  6. Support the transaxle with a jackstand.
  7. Remove the engine rear mount bracket. Refer to Engine Rear Mount Replacement .
    8. Fig 1: Identifying Transfer Case & Bolts
    GM2039429Courtesy of GENERAL MOTORS COMPANY
  8. Remove the transfer case bolts (1).
  9. Remove the transfer case (2).
scientia non olet · About LEMON Manuals