LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Exhaust System) >> Repair Instructions >> Exhaust Manifold Heat Shield Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Exhaust Manifold Heat Shield Bolts - Left Side
    GM1861578Courtesy of GENERAL MOTORS COMPANY
  1. Install the exhaust manifold heat shield, sliding the shield down over the HO2S pigtail.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the exhaust manifold heat shield bolts (1) and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1858010Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector (2) to the HO2S electrical connector (3).
  4. Install the HO2S electrical connector retainer to the wiring harness clip (1).
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals