LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Adjuster Track Adjustment >> Inspection and Cleaning Procedure

Inspection and Cleaning Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat. Refer to Rear Seat Removal and Installation (60%) Rear Seat Removal and Installation (40%) .
  2. Inspect the seat track for debris or foreign materials, if the track needs to be cleaned, perform the following steps:
      WARNING:

      Refer to Safety Glasses and Compressed Air Warning .

      NOTE:

      Use care when using compressed air to clear the sunroof drain hose. Do not exceed 241 kPa (35 psi).

    • Use a flexible wire or 689 kPa (100 psi) of compressed air to clear any material plugging the obstructing the seat track.
    • The mechanical components of the seat track assembly receive lubrication during assembly. If any seat track needs additional lubrication, use multi-purpose lubricant GM P/N 12346241 (Canadian P/N 10953474) or equivalent.
  3. Install the rear seat and test for proper operation. Refer to Rear Seat Removal and Installation (60%) Rear Seat Removal and Installation (40%) .
scientia non olet · About LEMON Manuals