LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS COMPANY
  1. Install the ignition coil(s).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the ignition coil bolt(s).

    Tighten 

    Tighten the bolt(s) to 10 N.m (89 lb in).

    3. Fig 2: View Of Ignition Coil Electrical Connector
    GM1860397Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals