Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Position the fuel feed/EVAP pipe assembly to the vehicle, and tighten the fuel feed/EVAP pipe clip (4) bolt.
Tighten
Tighten the bolt to 8 N.m (71 lb in).
- Install the fuel feed/EVAP pipe clip (2) and nut (3) to the stud.
Tighten
Tighten the nut to 9 N.m (80 lb in).
- Install the fuel feed/EVAP pipe clip (1) to the body.
- Connect the EVAP canister vent front pipe quick connect fitting (5) to the chassis EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel pump fuel feed pipe quick connect fitting (6) to the chassis fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
- Lower the vehicle.
- Remove the caps from the fuel rail and the EVAP purge solenoid.
- Connect the EVAP pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel feed pipe (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
- Tighten the fuel fill cap.
- Use the following procedure in order to inspect for leaks:
- Turn the ignition ON, with the engine OFF, for 2 seconds.
- Turn the ignition OFF for 10 seconds.
- Turn the ignition ON, with the engine OFF.
- Inspect for fuel leaks.
- Install the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
- Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
CAUTION:
Refer to Fastener Caution .