LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement .
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.
    5. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).
    6. Fig 3: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
  6. Remove the CMP sensor bolt and sensor (3).
scientia non olet · About LEMON Manuals