LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Actuator Solenoid Valve Bolt & Valve
    GM1860460Courtesy of GENERAL MOTORS COMPANY
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the CMP actuator solenoid valve (3) and bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector (6) to the bank 2 intake CMP actuator solenoid valve.
    4. Fig 3: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  4. Position and install the power steering fluid reservoir bracket (2).
  5. Install the power steering fluid reservoir bracket bolts (1).

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

  6. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement .
  7. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
scientia non olet · About LEMON Manuals