LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Parking Brake System) >> Repair Instructions >> Parking Brake Lever Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Park Brake Cable Locknut
    GM1862259Courtesy of GENERAL MOTORS COMPANY
  2. Loosen the park brake cable locknut (1) at the equalizer to relieve tension on the park brake cable.
  3. Lower the vehicle.
  4. Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  5. Remove the driver side front carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement .
  6. Disconnect the park brake warning indicator switch electrical connector.
    7. Fig 2: Front Park Brake Cable And Park Brake Pedal Clevis
    GM1862251Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the front park brake cable from the park brake pedal clevis (1).
  8. Using the J 37043  parking brake cable release tool, remove the front park brake cable from the park brake pedal assembly by compressing the locking tabs on the cable conduit (2).
    9. Fig 3: Lower Park Brake Pedal Nut
    GM1862252Courtesy of GENERAL MOTORS COMPANY
  9. Apply the park brake pedal until the clevis exposes the lower park brake pedal nut.
  10. Remove the lower park brake pedal nut (1).
    11. Fig 4: Upper Park Brake Pedal Nuts
    GM1862253Courtesy of GENERAL MOTORS COMPANY
  11. Remove the 2 upper park brake pedal nuts (1).
  12. Remove the park brake pedal assembly.
scientia non olet · About LEMON Manuals