LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 434 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Ignition and Start Switch Housing Replacement

Ignition and Start Switch Housing Replacement

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition And Start Switch Housing
GM1866492Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement .
1 Ignition and Start Switch Housing Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
8 N.m (71 lb in)
2 Ignition and Start Switch Housing Strap
3 Ignition and Start Switch Housing

Procedure

  1. Disconnect any electrical connectors as needed.
  2. Transfer any parts as needed.
scientia non olet · About LEMON Manuals