LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 420 (Hydraulic Brake System) >> Repair Instructions >> Power Brake Booster Auxiliary Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Brake Booster Auxiliary Pump Bracket And Bolts
    GM2080959Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. If removed, install the power brake booster auxiliary pump bracket bolts (1) and bracket (2) and tighten the bolts to 10 N.m (89 lb in).
    2. Fig 2: Power Brake Booster Auxiliary Pump Insulators And Sleeves
    GM2080956Courtesy of GENERAL MOTORS COMPANY
  2. If removed, install the power brake booster auxiliary pump insulators (1) and sleeves (2).
  3. Install the power brake booster auxiliary pump bolts and the pump to the bracket.
    4. Fig 3: Power Brake Booster Auxiliary Pump Nuts
    GM2080951Courtesy of GENERAL MOTORS COMPANY
  4. Install the power brake booster auxiliary pump nuts (1) and tighten the nuts to 10 N.m (89 lb in).
    5. Fig 4: Power Brake Booster Auxiliary Pump Electrical Connector
    GM2080948Courtesy of GENERAL MOTORS COMPANY
  5. Install the power brake booster auxiliary pump electrical connector (1) to the bracket.
  6. Connect the power brake booster auxiliary pump electrical connector.
    7. Fig 5: Vacuum Brake Booster Hose Quick-Connect Fitting
    GM2080944Courtesy of GENERAL MOTORS COMPANY
  7. Connect the quick connect (2) to the power brake booster auxiliary pump.
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals