LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Steering) >> Gearbox Mount Cushion Replacement

Gearbox Mount Cushion Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gearbox (see INSTALLATION  ).
  2. Position a 34 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 105 mm flange bolt (C), and a 10 mm nut (D) as shown.
    Fig 1: Positioning Socket On Flange Part Of Gearbox Housing
    G06430457Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Hold the flange bolt with a wrench, and tighten the nut with a wrench. Remove the gearbox mount cushion (E).
  4. Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place it on the gearbox mounting cushion hole.
    Fig 2: Identifying Gearbox Mount Cushion Surface
    G06430458Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Position the 34 mm socket on the flange part of the gearbox housing with a washer, a flange bolt, and a nut as shown.
  6. Install the gearbox mount cushion by tightening the nut until the mount cushion edges (B) contact the gearbox flange surface.
  7. Install the steering gearbox (see INSTALLATION  ).
scientia non olet · About LEMON Manuals