LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Steering) >> EPS Motor Removal and Installation >> Removal

EPS Motor Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gearbox (see INSTALLATION  ).
  2. Remove the torque sensor 4P connector (A) from the connector bracket (B).
    Fig 1: Identifying Torque Sensor 4P Connector And Connector Bracket
    G06430508Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the connector bracket mount bolt (A), then remove the EPS motor (B) and the O-ring (C).
    Fig 2: Identifying Connector Bracket Mount Bolt And EPS Motor
    G06430509Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals