LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Rear Suspension) >> Stabilizer Bushing Replacement

Stabilizer Bushing Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift (see LIFT AND SUPPORT POINTS ).
  2. Remove the dynamic damper from the axle beam (see DYNAMIC DAMPER REPLACEMENT  ).
  3. Remove the stabilizer bushing (A) from the axle beam.
    Fig 1: Identifying Stabilizer Bushing From Axle Beam
    G06430650Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Apply silicone spray (P/N 08209-0001) to the new stabilizer bushing. This will ease installation of the bushing into the stabilizer and the axle beam.
  5. Make a mark (A) near the hole (B) of the axle beam as shown. Install the stabilizer bushing (C) into the axle beam by aligning the end face of the stabilizer bushing to the plant mark.
    NOTE: Make sure the stabilizer bushing is installed into the stabilizer (D).
    Fig 2: Mark Hole Of Axle Beam With Torque Specification
    G06430651Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the dynamic damper on the axle beam (see DYNAMIC DAMPER REPLACEMENT  ).
scientia non olet · About LEMON Manuals