LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Side Impact Sensor (Second) Replacement >> Removal

Side Impact Sensor (Second) Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the cargo area side trim panel (see TRIM REMOVAL/INSTALLATION - CARGO AREAS ).
  3. Disconnect the wire harness 2P connector (A) from the side impact sensor (second) (B).
    Fig 1: Identifying Wire Harness 2P Connector And Side Impact Sensor (Second)
    G06432308Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Using a TORX T30 bit, remove the TORX bolt (C) then remove the side impact sensor (second).
scientia non olet · About LEMON Manuals