LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> SRS Unit Replacement >> Removal

SRS Unit Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
  3. Remove the heater joint duct (see step 7 DASHBOARD/STEERING HANGER BEAM REMOVAL/INSTALLATION ).
  4. Disconnect SRS unit connectors (A) from the SRS unit.
    Fig 1: Identifying SRS Unit Connectors And TORX Bolts
    G06432304Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the TORX bolts (B) using a TORX T30 bit, then pull out the SRS unit.
scientia non olet · About LEMON Manuals