DTC 85-71, 85-78: ODS Unit Not Initialized
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed ( see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES ), General Troubleshooting Information (see GENERAL TROUBLESHOOTING INFORMATION ), and 12 Volt Battery Terminal Disconnection and Reconnection (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software (see SRS UNIT UPDATE ) and retest.
- Clear the DTC memory (see HOW TO CLEAR DTCS ).
- Turn the ignition switch to ON (II), then wait for 10 seconds.
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 85-71 or 85-78 indicated?
YES -Go to step 4.
NO -Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures (see TROUBLESHOOTING INTERMITTENT FAILURES ). If another DTC is indicated, troubleshoot the DTC.
- Do the ODS unit initialization (see ODS UNIT INITIALIZATION ).
- Turn the ignition switch to LOCK (0), then wait for 10 seconds.
- Turn the ignition switch to ON (II), then wait for 10 seconds.
- Read the DTC (see HOW TO RETRIEVE DTCS
).
Is DTC 85-71 or 85-78 indicated?
YES -Faulty ODS unit, replace the ODS unit (see ODS UNIT REPLACEMENT ), then clear the DTC. If the DTC is still present, replace the SRS unit (see SRS UNIT REPLACEMENT ).
NO -The system is OK at this time.