LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> General Troubleshooting Information >> How to Retrieve DTCs

How to Retrieve DTCs

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure the 12 volt battery is fully charged before you begin.
  1. Make sure the ignition switch is in LOCK (0).
  2. Connect the HDS to the data link connector (DLC) (A).
    Fig 1: Identifying Data Link Connector
    G06432104Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch to ON (II).
  4. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  5. Use the HDS to check for SRS DTCs.
  6. Read and record the DTC.
    NOTE:
    • Only read DTCs from the SRS menu, not from SWS menus unless instructed to check SWS DTCs. SWS (ODS unit) DTCs are subcodes of SRS unit DTCs. Only troubleshoot the corresponding SRS DTCs.
    • Do not clear the DTC until instructed by the troubleshooting procedure.
  7. Turn the ignition switch to LOCK (0), then wait for 10 seconds.
  8. Disconnect the HDS from the DLC.
  9. Do the troubleshooting procedure for the DTC.
scientia non olet · About LEMON Manuals