LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Air Conditioning Compressor Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Belt Installation Tool
    GM1987657Courtesy of GENERAL MOTORS CORP.
  1. Position the belt behind the rear face of the balancer (1) and off of the A/C pulley (2).
  2. Install the belt installation tool (3) onto the balancer.
    3. Fig 2: InstallingBelt
    GM1987659Courtesy of GENERAL MOTORS CORP.
    NOTE: For RPO L99 applications, it may be necessary to loosen and reposition or remove the camshaft position sensor/actuator wire harness bracket for belt installation.
  3. Slide the belt installation tool (1) upward, installing the belt (2) onto the belt installation tool.
    4. Fig 3: View Of CMP Sensor Wire Harness & Bolts
    GM1658163Courtesy of GENERAL MOTORS CORP.
  4. Loosen the camshaft position sensor/actuator wire harness bracket bolts (738) and reposition or remove the bracket (737) as required.
  5. Slide the belt installation tool downward, positioning the belt onto the A/C pulley, applying light tension to the belt.
    6. Fig 4: Positioning Lower Portion Of Belt
    GM1987663Courtesy of GENERAL MOTORS CORP.
  6. Position the lower portion of the belt (1) with the ribbed area facing forward.
    7. Fig 5: Rotating Crankshaft Pulley
    GM1987677Courtesy of GENERAL MOTORS CORP.
  7. Slowly rotate the crankshaft pulley (1) in a clockwise direction while using finger pressure to pull the belt (2) forward. Ensure that the ribbed area of the belt remains facing forward and the belt aligns properly to the A/C pulley.
    8. Fig 6: Drive Belt Alignment
    GM1987679Courtesy of GENERAL MOTORS CORP.
  8. Inspect the drive belt (1) for proper installation and alignment.
    9. Fig 7: Rotating Balancer
    GM1987684Courtesy of GENERAL MOTORS CORP.
  9. Rotate the balancer (1) and additional 360 degrees to ensure proper belt installation.
    10. CAUTION: Refer to Fastener Caution .
  10. Reposition the camshaft position sensor/actuator wire harness bracket and tighten the bolts as required.

    Tighten the bolts to 12 N.m (106 lb in).

  11. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals