LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Backup Lamp Switch & Electrical Connector & Vehicle Speed Sensor
    GM1426237Courtesy of GENERAL MOTORS CORP.
  1. Install the vehicle speed sensor (1).
  2. CAUTION: Refer to Fastener Caution .
  3. Install the vehicle speed sensor bolt and tighten to 10 N.m (89 lb in).
  4. Connect the vehicle speed sensor electrical connector.
  5. Lower the vehicle.