LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Main Shaft Rear Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Transmission Case Extension Seal
    GM794670Courtesy of GENERAL MOTORS CORP.
    NOTE: Install the seal onto the tool before installing into the case to prevent damage to the seal.
  1. Using J 44765  install the new transmission case extension seal (1).
    2. Fig 2: Drive Flange & Thrust Washer
    GM1430041Courtesy of GENERAL MOTORS CORP.
  2. Install the drive flange to the transmission output shaft.
  3. Install a NEW drive flange thrust washer.
    4. Fig 3: View Of Flange Tool
    GM804354Courtesy of GENERAL MOTORS CORP.
  4. Install the J 45012  to the drive flange.
    5. CAUTION: Refer to Fastener Caution .
  5. While holding J 45012  , install a NEW drive flange nut using J 29873  . See Special Tools .

    Tighten the drive flange nut to 57 N.m (42 lb ft).

  6. Remove the J 45012  from the drive flange.
    7. Fig 4: Identifying Propeller Shaft Components
    GM1236100Courtesy of GENERAL MOTORS CORP.
  7. Install the propeller shaft (6). Refer to Two-Piece Propeller Shaft Replacement
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals