LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Gear Select/Skip Shift Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Reverse Lockout Solenoid
    GM1426253Courtesy of GENERAL MOTORS CORP.
  1. If removed, inspect the solenoid O-ring. Replace the O-ring if necessary.
    2. CAUTION: Refer to Fastener Caution
  2. Install the solenoid and tighten the solenoid to 40 N.m (30 lb ft).
  3. Connect the solenoid electrical connector.
  4. Install the transmission support to body retaining bolts. Refer to Transmission Mount Replacement
  5. Remove the transmission jack.
  6. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement
  7. Install the exhaust system.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals