LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Backup Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Backup Lamp Switch & Electrical Connector & Vehicle Speed Sensor
    GM1426237Courtesy of GENERAL MOTORS CORP.
  1. Apply pipe sealant with Teflon® to the threads of the backup lamp switch. Use GM P/N 1052080 or equivalent.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the backup lamp switch (2) and tighten the switch to 27 N.m (20 lb ft).
  3. Install the backup lamp switch wire harness to the bracket.
  4. Connect the backup lamp switch electrical connector (3).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals