LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Transmission Disassemble >> Reverse Shift Fork Removal

Reverse Shift Fork Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Reverse Synchronizer & Reverse Shift Fork Retainer Rings
    GM2397549Courtesy of GENERAL MOTORS CORP.
  1. Remove the reverse synchronizer retainer ring (1).
  2. Remove and discard the reverse shift fork retainer ring (2).
    3. Fig 2: View Of Alignment Marks On Synchronizer Hub & Synchronizer Sleeve
    GM4810Courtesy of GENERAL MOTORS CORP.
  3. Scribe a mark on the synchronizer hub and on the sleeve. This will help you to reinstall the parts in the same position.
    4. Fig 3: Reverse Shift Fork Components
    GM2397550Courtesy of GENERAL MOTORS CORP.
  4. Remove the reverse shift fork and synchronizer (1) and inserts.
  5. Pry to remove the reverse synchronizer hub.
  6. Remove the locking ring (2).
  7. Remove the two piece thrust washer (3).
scientia non olet · About LEMON Manuals