Countershaft Gear Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the reverse counter shaft retainer ring.
- Remove the reverse countershaft gear (2) using J 22888-20A: puller (1).
- Remove the 5th gear countershaft retainer and spacer.
- Remove the 5th gear from the countershaft.
- Remove the 5th gear needle bearing from the countershaft.
- Remove the 5th gear spacer from the countershaft.
- Remove the 5th and 6th gear synchronizer hub retainer ring from the countershaft.
- Remove the 5th/6th speed shift fork retainer ring.