LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Transmission Assemble >> Reverse Speed Gear Installation

Reverse Speed Gear Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Reverse Gear Components
    GM2397548Courtesy of GENERAL MOTORS CORP.
  1. Install the following parts in order:
    1. The reverse gear blocking ring assembly (5), including the following components:
      • Reverse gear inner ring (6)
      • Reverse gear outer ring (7)
      • Reverse gear blocking ring (8)
    2. The caged needle bearing (4)
    3. The reverse speed gear (3)
    4. The thrust washer (2)
    5. The retainer ring (1)
    2. Fig 2: Rear Bearing Retainer Ring, Spacers & Mainshaft Rear Roller Bearing
    GM2397547Courtesy of GENERAL MOTORS CORP.
  2. Install the following parts in order:
    1. The spacer (3)
    2. The roller bearing (2)
    3. The spacer (3)
    4. The roller bearing retainer ring (1)
    3. Fig 3: Locking Ball, Speed Sensor Rotor & Snap Ring
    GM2397849Courtesy of GENERAL MOTORS CORP.
  3. Install the following parts in order:
    • The locking ball (3)
    • The speed sensor rotor (2) using J 38205-1:  press tube
    • The snap ring (1)
    4. Fig 4: Offset Shift Lever & Shift Guide Rollpin
    GM2397545Courtesy of GENERAL MOTORS CORP.
  4. Install the extension housing main shaft bearing race (3).
  5. Install the shift shaft extension (2).
  6. Install NEW shift guide roll pin (1).
    7. Fig 5: Identifying Plug, Spring & Shift Detent Roller
    GM2102199Courtesy of GENERAL MOTORS CORP.
  7. Lift up on the shift shaft extension while installing the shift detent roller (3), spring (2) and plug (1). Tighten the plug to 24 N.m (18 lb in).
scientia non olet · About LEMON Manuals