LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Transmission Assemble >> 5th Speed Driven Gear and 6th Speed Drive Gear Installation

5th Speed Driven Gear and 6th Speed Drive Gear Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of 6th Driven Gear, Caged Needle Bearing, And Spacers
    GM1887546Courtesy of GENERAL MOTORS CORP.
  1. Install two spacers, caged needle bearing, and 6th drive gear.
    2. Fig 2: 6th Speed Drive Gear Components
    GM1887543Courtesy of GENERAL MOTORS CORP.
  2. Install the 6th speed drive gear inner cone, 6th speed drive gear friction cone, and synchronizer blocking ring.
    3. Fig 3: Identifying Synchronizer Hub Assembly
    GM2178188Courtesy of GENERAL MOTORS CORP.
  3. Install the 5th/6th synchronizer hub assembly (2) using J 38205-1:  tube (1).
    4. Fig 4: 5th/6th Synchronizer Components
    GM1887538Courtesy of GENERAL MOTORS CORP.
  4. Install the following components:
    • Drive gear inner cone
    • Drive gear friction cone
    • Synchronizer blocking ring
    • Synchronizer inserts
    • Synchronizer sleeve
    • 5th/6th shift fork
    5. Fig 5: View Of 5th/6th Speed Shift Fork Retainer Ring
    GM1887535Courtesy of GENERAL MOTORS CORP.
  5. Install the 5th/6th speed shift fork retainer ring.
    6. Fig 6: 5th & 6th Gear Synchronizer Hub Retainer Ring
    GM1887537Courtesy of GENERAL MOTORS CORP.
  6. Install the retainer clip to the countershaft.
    7. Fig 7: Installing 5th/6th Speed Driven Gear
    GM2397843Courtesy of GENERAL MOTORS CORP.
  7. Install the 5th/6th speed driven gear (1) by heating to 54°C (130°F). The smaller outside diameter (OD) of the gear faces down.
scientia non olet · About LEMON Manuals