LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Manual Transmission - TREMEC 6-Speed) >> Diagnostic Information and Procedures >> DTC P0801 >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Turn OFF the ignition for 60 seconds.
  5. Engine running, command the reverse lockout solenoid ON and OFF with a scan tool, while observing the reverse inhibit circuit status parameters. The circuit status parameters should change from OK to Not Run or Not Run to OK.