LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - AISIN AY6) >> Repair Instructions - On Vehicle >> Shift Control Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front floor console front cover. Refer to Front Floor Console Front Cover Replacement (Without UMQ) or Front Floor Console Front Cover Replacement (With UMQ)
  2. Remove the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement 
  3. Remove the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (H-Pipe) or Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement (Vehicle Service)
  4. Disconnect the propeller shaft from the transmission and position out of the way. Refer to Two-Piece Propeller Shaft Replacement
  5. Support the transmission with a suitable jack.
  6. Remove the transmission support.
  7. Lower the rear of the transmission in order to gain access to the top of the transmission.
    8. Fig 1: Identifying Shift Control Rod Pin Retainers
    GM1979754Courtesy of GENERAL MOTORS CORP.
  8. Using a flat-blade tool, release the left and right side shift control rod pin retainers (1,3).
  9. Using a flat-blade tool, release the center shift control rod pin retainer (2).
    10. Fig 2: Identifying Shift Control Rod Pins
    GM1979753Courtesy of GENERAL MOTORS CORP.
  10. Remove the left and right side shift control rod pins (1, 3).
  11. Remove the center shift control rod pin (2).
  12. Remove the shift control mounting nuts.
  13. Remove the manual transmission control assembly from the vehicle.
scientia non olet · About LEMON Manuals