Extension Disassemble

Special Tools

• DT-47722:  Shift Shaft Seal Installer
• J 2619-01:  Slide Hammer
• J 26941:  Bushing and Bearing Remover 3-4 in

For equivalent regional tools, refer to Special Tools .

Fig 1: Removing Rear Output Shaft Seal
Courtesy of GENERAL MOTORS CORP.
NOTE: The extension must be held down firmly to remove the output shaft seal.
1. Using J 2619-01:  slide hammer (1) and J 26941:  remover (2), remove the rear output shaft seal (92).
Fig 2: Removing Rear Output Shaft Bearing Assembly
Courtesy of GENERAL MOTORS CORP.
NOTE: The extension must be held down firmly to remove the output shaft bearing.
2. Using J 2619-01:  slide hammer (1) and J 26941:  remover (2), remove the rear output shaft bearing assembly (89).
Fig 3: Identifying Shift Shaft Seal
Courtesy of GENERAL MOTORS CORP.
3. Using tool DT-47722:  seal installer, remove the shift shaft seal (88).