LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (1 Of 3)) >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Sensor Grommet, MAP Sensor & Bolt
    GM1876003Courtesy of GENERAL MOTORS CORP.
    NOTE: The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.
  1. Remove the manifold absolute pressure (MAP) sensor bolt (713).
  2. Remove the MAP sensor (714).
  3. Remove the seal (715) from the sensor, as required.
    4. Fig 2: Identifying Evaporative Emission Components
    GM1876004Courtesy of GENERAL MOTORS CORP.
  4. Remove the evaporative emission (EVAP) clip (740), bolt (742), bracket (741), canister purge solenoid valve (730), and tubes (729 and 735).
    5. Fig 3: Removing/Installing Positive Crankcase Ventilation (PCV) Hose
    GM1876005Courtesy of GENERAL MOTORS CORP.
  5. Remove the positive crankcase ventilation (PCV) hose - dirty air (716).
    6. Fig 4: Identifying Intake Manifold, Bolts & Fuel Rail Stop Brackets
    GM1876006Courtesy of GENERAL MOTORS CORP.
  6. Remove the intake manifold bolts (512) and fuel rail stop brackets (712).
  7. Remove the intake manifold (500).
    8. Fig 5: View Of Intake Manifold-To-Cylinder Head Gaskets
    GM1876007Courtesy of GENERAL MOTORS CORP.
  8. Remove the intake manifold gaskets (514).
  9. Discard the intake manifold gaskets.
scientia non olet · About LEMON Manuals