LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - 6.2L - Repair Instructions - Off Vehicle (1 Of 3)) >> Fuel Rail and Injectors Removal

Fuel Rail and Injectors Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Fuel Rail & Injectors
    GM1876000Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Fuel Rail Stop Bracket Installation Warning .
    NOTE:
    • The intake manifold, throttle body, fuel injection rail and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the intake manifold as a complete assembly.
    • Do not separate the fuel injectors from the fuel rail unless component service is required.
    • Use cleanliness and care when handling the fuel system components. Do not allow dirt or debris to enter the fuel injectors or fuel rail components. Cap ends as necessary.
  1. Note the location of the fuel rail ground strap (557).
    2. Fig 2: Removing/Installing Bolts, Ground Strap, Fuel Rail & Injectors
    GM1876001Courtesy of GENERAL MOTORS CORP.
  2. Remove the bolts (511 and 512), ground strap (557), and fuel rail with injectors (510). Lift evenly on both sides of the fuel rail until all injectors have left their bores.
    3. Fig 3: Fuel Injectors & Retainers
    GM1552482Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel injectors (533) and retainers (521).
  4. Remove the O-rings (532 and 534), as required.
  5. Remove the cap (523) and service valve (524), as required.
scientia non olet · About LEMON Manuals