Rear Window Wiper Motor Replacement (Traverse)

Fig 1: Identifying Rear Window Wiper Motor (Traverse)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement (Enclave) or Liftgate Trim Panel Replacement (Traverse) or Liftgate Trim Panel Replacement (Acadia or OUTLOOK) . Remove the rear wiper arm assembly. Refer to Rear Window Wiper Arm Replacement (Acadia) or Rear Window Wiper Arm Replacement (Enclave, Outlook ) or Rear Window Wiper Arm Replacement (Traverse) . Disconnect the electrical connector to the rear window wiper motor.
1	Rear Window Wiper Motor Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten: 9 N.m (80 lb in)
2	Rear Window Wiper Motor Assembly Tip: Ensure the rear window wiper pivot shaft seal in the liftgate rear window is not damaged when the wiper motor pivot shaft is pulled from the seal. Replace the pivot shaft seal if damaged.

Callout

Component Name

Preliminary Procedures

Rear Window Wiper Motor Bolt (Qty: 3)

CAUTION: Refer to Fastener Caution .

Tighten: 9 N.m (80 lb in)

Rear Window Wiper Motor Assembly
Tip:

Ensure the rear window wiper pivot shaft seal in the liftgate rear window is not damaged when the wiper motor pivot shaft is pulled from the seal.
Replace the pivot shaft seal if damaged.