Rear Window Wiper Motor Replacement (OUTLOOK)

Fig 1: View Of Rear Window Wiper Motor (Outlook)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the rear liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement (Enclave) or Liftgate Trim Panel Replacement (Traverse) or Liftgate Trim Panel Replacement (Acadia or OUTLOOK) . Remove the rear wiper arm assembly. Refer to Rear Window Wiper Arm Replacement (Acadia) or Rear Window Wiper Arm Replacement (Enclave, Outlook ) or Rear Window Wiper Arm Replacement (Traverse) . Disconnect the electrical connector.
1	Rear Window Wiper Arm Nut CAUTION: Refer to Fastener Caution . Tighten: 19 N.m (14 lb ft)
2	Rear Window Wiper Pivot Shaft Gasket Procedure: Align the tab on the gasket to the slot on the rear wiper motor upon assembly.
3	Rear Window Wiper Motor Bolt (Qty: 2) Tighten: 10 N.m (89 lb in)
4	Rear Window Wiper Motor Assembly