LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Impala Police >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

    Fig 1: Transaxle Mount
    GM462438Courtesy of GENERAL MOTORS CORP.
  1. Position the transaxle mount to the frame.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the transaxle mount lower nuts to the frame.

    Tighten:  Tighten the transaxle mount lower nuts to 63 N.m (46 lb ft).

  3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.
    4. Fig 2: Raising Transaxle Assembly
    GM630964Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle mount upper nuts to the transaxle mount.

    Tighten:  Tighten the transaxle mount upper nuts to 47 N.m (35 lb ft).

  5. Remove the transmission jack from the transaxle.
  6. Install the left engine splash shield. Refer to Engine Splash Shield Replacement (Left) or Engine Splash Shield Replacement (Right) .
  7. Install the left wheel and tire assembly.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals