LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount To Side Rail Nuts
    GM1623161Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the side rail studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine mount to side rail nuts.

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. Fig 2: Identifying Engine Mount To Bracket Bolts
    GM1623160Courtesy of GENERAL MOTORS CORP.
    NOTE: The engine mount to bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Install the engine mount to bracket bolts.
  4. Tighten the engine mount to bracket bolts in the following sequence.
    1. Middle
    2. Rear
    3. Front

      Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Remove the hydraulic floor jack from under the oil pan.
  6. Install the windshield washer solvent reservoir. Refer to Windshield Washer Solvent Container Replacement .
  7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals