LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount To Bracket Bolts
    GM1623160Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  2. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  4. Remove the windshield washer solvent reservoir. Refer to Windshield Washer Solvent Container Replacement .
  5. Install the engine support fixture. Refer to Engine Support Fixture .
  6. Remove the engine mount to bracket bolts.
    7. Fig 2: Identifying Engine Mount To Side Rail Nuts
    GM1623161Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine mount to side rail nuts.
  8. Remove the engine mount from the engine compartment.
    9. Fig 3: Identifying Engine Mount Bracket
    GM1623162Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bracket to engine bolts.
  10. Remove the engine mount bracket.
    11. Fig 4: Identifying Engine Front Cover & Water Pump Bolt
    GM1578293Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine front cover to water pump bolt.
    12. Fig 5: Identifying Engine Front Cover & Bolts
    GM1578292Courtesy of GENERAL MOTORS CORP.
  12. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  13. Remove the engine front cover bolts.
  14. Remove the engine front cover.
    15. Fig 6: View Of Engine Front Cover Gasket
    GM1578294Courtesy of GENERAL MOTORS CORP.
  15. Remove and discard the engine front cover gasket.
scientia non olet · About LEMON Manuals