LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Shift Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Apply the parking brake.
  2. Shift the transmission to neutral (N).
  3. Remove the console. Refer to Front Floor Console Replacement
    4. Fig 1: Identifying Shift Cable Retainers
    GM1617434Courtesy of GENERAL MOTORS CORP.
  4. Lift up the cable retainers.
  5. Disconnect cable ends from the shift control assembly, noting the location for assembly.
    6. Fig 2: View Of Shift Cables, Cable Connections & Shift Cable Bracket
    GM880090Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the cable ends from the transmission shift levers, noting the location for assembly.
  7. Remove the shift cable from the transmission cable bracket.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  9. Remove the shift cable attachment nut from the underbody.
  10. Lower the vehicle.
  11. Remove the left instrument panel closeout panel. Refer to Front Floor Console Extension Replacement - Side
  12. Position the drivers side front carpet aside. Refer to Floor Panel Carpet Replacement
    13. Fig 3: Locating Floor Pan Grommet & Mounting Nuts
    GM867994Courtesy of GENERAL MOTORS CORP.
  13. Separate the grommet (1) from the floor pan.
  14. Remove the cable from the vehicle by pulling the cables through the drivers floor opening.
scientia non olet · About LEMON Manuals