LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Axle Shaft Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Illustrating Installation Of Wheel Drive Shaft Into Transaxle Through J 44394
    GM857191Courtesy of GENERAL MOTORS CORP.
  1. Use the J 44385  and the J 7079-2  in order to install a new seal. See Special Tools . Ensure the seal is seated flush to the outer bore area.
  2. Lubricate the seal with transmission fluid. Refer to Lubrication Specifications .
  3. Install the wheel driveshaft. Refer to Wheel Drive Shaft Replacement .
  4. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals