LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Counter Gear Shaft Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Special Tools J 22912-O1 & J 39473
    GM1748681Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not replace tapered bearings unless inspection shows bearing damage.
  1. Remove the small tapered bearing, using the J 22912-B  (1) with the J 39473  (2) and a hydraulic press. See Special Tools .
  2. Discard the small tapered bearing.
    3. Fig 2: View Of Tapered Bearing, Special Tools J 39511 & J 39547
    GM1748682Courtesy of GENERAL MOTORS CORP.
  3. Remove the large tapered bearing, using the J 39511  (2), the J 39547  (1), and a hydraulic press. See Special Tools .
  4. Discard the large tapered bearing.
scientia non olet · About LEMON Manuals